Juniper JUNOS SOFTWARE 10.2 - SOFTWARE INSTALLATION AND UPGRADE GUIDE 4-28-2010 Upgrade Manual page 76

JUNOS Release 10.2 Software Installation and Upgrade Guide
Complete the Management Console Configuration
To configure the global management console parameters.
1.
2.
3.
4.
5.
Commit and Synchronize Changes
Commit the configuration changes. When you issue the
configuration is shared between both Routing Engines and committed on both Routing
Engines simultaneously.
1.
54
Complete the Management Console Configuration
root# set apply-groups [ re0 re1 ]
Configure the IP address of the DNS server.
[edit]
root# set system name-server address
Configure the router domain name.
[edit]
root# set system domain-name domain-name
Configure the IP address of a backup router. The backup router is used while the
local router is booting and if the routing process fails to start. Once the routing
process starts, the backup router address is removed from the local routing and
forwarding tables. For more information about the backup router, see the JUNOS
System Basics Configuration Guide.
[edit]
root# set system backup-router address
(Optional) Configure the static routes to remote subnets with access to the
management port. Access to the management port is limited to the local subnet.
To access the management port from a remote subnet, you need to add a static
route to that subnet within the routing table. For more information about static
routes, see the JUNOS System Basics Configuration Guide.
[edit]
root# set routing-options static route remote-subnet next-hop destination-IP
retain no-readvertise
Configure telnet service at the
[edit]
root# set system services telnet
Before committing the configuration, you can review the configuration entries
using the show command.
root# show
## Last changed: 2008-10-17 18:32:25 UTC
version 9.1R1.8;
groups {
re0 {
hierarchy level.
[edit system services]
synchronize
command, the