Juniper JUNOS SOFTWARE 10.2 - SOFTWARE INSTALLATION AND UPGRADE GUIDE 4-28-2010 Upgrade Manual page 75

To use as an out-of-band management Ethernet interface, you must
em0
configure its logical port,
For a T1600 standalone router (not connected to a TX Matrix Plus router
and not in a routing matrix):
[edit]
root@# set interfaces fxp0 unit 0 family inet address address/prefix-length
Return to the top level of the hierarchy.
5.
[edit groups re0]
root# top
Create the configuration group
6.
[edit]
root# set groups re1
Navigate to the groups re1
7.
[edit]
root# edit groups re1
Specify the router hostname.
8.
[edit groups re1]
root# set system host-name host-name
Configure the IP address and prefix length for the router Ethernet interface.
9.
For all routers except the TX Matrix Plus router and T1600 routers in a routing
matrix:
[edit]
root@# set interfaces fxp0 unit 0 family inet address address/prefix-length
For TX Matrix Plus and T1600 routers in a routing matrix only:
[edit]
root@# set interfaces em0 unit 0 family inet address address/prefix-length
To use as an out-of-band management Ethernet interface, you must
em0
configure its logical port,
For a T1600 standalone router (not connected to a TX Matrix Plus router
and not in a routing matrix):
[edit]
root@# set interfaces fxp0 unit 0 family inet address address/prefix-length
Return to the top level of the hierarchy.
10.
[edit groups re0]
root# top
Specify the group application order.
11.
[edit]
Chapter 5: Completing a Recovery Installation
em0.0 , with a valid IP address.
.
re1
level of the configuration hierarchy.
em0.0 , with a valid IP address.
Set Up Routing Engine Configuration Groups
53