Installing the FIPS Enclosure
Install the front panel inside the front surround panel and secure it with the nine screws you removed in
Step 11
Step 5. See
Figure 19
Installing the Rear Shield Assembly
To install the rear shield assembly, perform the following steps:
Position the rear shield assembly on the rear of the chassis and align the rear shield panel holes with the
Step 1
holes on the rear of the chassis.
Secure the shield into place using the screws provided in the kit. See
Step 2
Figure 20
Cisco ASA 5580 Series Adaptive Security Appliance Hardware Installation Guide
3-18
Figure
19.
Installing the Front Panel to the Front Surround Panel
Install the Rear Shield on the Rear of the Chassis
Chapter 3
Installing the ASA 5580
Figure
20.
OL-12920-01