Removing and Installing Fans
Figure 4-9
P S 2
UI D
Installing the Fan
To install fans in the ASA, perform the following steps:
To install a new fan, position the fan over the slot so that the connector below the fan indicator lines up
Step 1
with the connection on the motherboard (for the location of the connector, see
Push down until the fan clicks into place.
Step 2
Check to make sure the indicator on each fan is green.
Step 3
Note
Replace the chassis cover.
Step 4
Slide the ASA back in to the rack by pressing the rail-release handles.
Step 5
Cisco ASA 5580 Series Adaptive Security Appliance Hardware Installation Guide
4-12
Removing the Fan
PC I-E x4
PC I-E x8
9
8
PC I-E x4
7
PC I-E x8
6
If the front panel internal system health indicator is not green after you install a fan, reseat the
fan.
PC I-E x4
5
4
PC I-X 10
3
0 M H z
2
1
CO NS OL
E
MG MT 0/1
MG MT 0/0
Chapter 4
Maintenance and Upgrade Procedures
P S 1
Figure
4-8).
OL-12920-01