Cisco 5580-40 - ASA Firewall Edition Hardware Installation Manual page 46

Installing the FIPS Enclosure
Release the latches on the lever, see
Step 3
Lower the handle, and pull the module out of the ASA until the release latches catch.
Step 4
Figure 15
Remove the five screws from the top and four screws on the sides of the front shield assembly. Keep the
Step 5
screws in a secure place for later use.
The front shield assembly consists of a front surround panel that has double-sided tape, and a front panel.
See Figure
Figure 16
Step 6 Clean the chassis of any grease, dirt or oil with alcohol where the self-adhesive tape will stick on the
chassis.
Cisco ASA 5580 Series Adaptive Security Appliance Hardware Installation Guide
3-16
Figure
Releasing the Latch and Lowering the Handle
16.
Front Surround Panel and the Front Panel
15.
Chapter 3 Installing the ASA 5580
OL-12920-01