Electrical Requirements - Kenmore 11069912990 Owner's Manual And Installation Instructions

C.
MAKE ELECTRICAL
CONNECTION
It is your responsibility:
• To contact a qualified electrical installer.
• To assure that the electrical installation
is adequate and in conformance with
the National Electrical Code, ANSI/NFPA
70 - latest edition and all local codes
and ordinances.
Copies of the code standards listed above
may be obtained from:
National Fire Protection Association
Batterymarch Park
Quincy, Massachusetts 02269
ELECTRICAL REQUIREMENTS
OrteJiirj'e_m "I_ i[_ _,,,
The proper electrical connection
ensures a safe installation that
meets local code requirements.
A three-wire or four-wire, single phase,
120/240-volt, 60-Hz., AC-only, electrical
supply (or three-wire or four-wire,
120/208-volt if specified on serial/rating
plate) is required on a separate
30-ampere circuit, fused on both sides of
the line. A time-delay fuse or circuit
breaker is recommended.
This dryer is manufactured with the
3-wire, frame-grounding conductor
connected to the NEUTRAL (white or
center) of the wiring harness of the
terminal block. Do not have a fuse in
the neutral or grounding circuit. A fuse
in the neutral or grounding circuit could
result in an electrical shock.
Use a 4-conductor cord when the
dryer is installed in a mobile home or
an area where local codes do not
permit grounding through the neutral.
ELECTRICAL CONNECTION OPTIONS
IfYeur Home Has:
3-wire electrical
receptacle
(NEMA Type 10-30R)
And You Will Be Go To
Connecting To: Page
A U.L.-listed, 120/240-volt
minimum, 30-amp., dryer
power supply cord.*
3-wire direct
14-I.
4-wire electrical
receptacle
(NEMA Type 14-30R)
A fused disconnect or 16 - II.
circuit breaker box.*
A U.L.-listed, 120/240-volt
minimum, 30-amp., dryer
power supply cord.
19 - III.
4-wire direct
A fused disconnect or 22 - IV.
circuit breaker box.
*if local codes do not permit the connection of a frame-grounding conductor
to the neutral wire, see the instructions on page 18.
I3