Kenmore 11069912990 Owner's Manual And Installation Instructions page 23

STEP 3. Attach a _-inch, U.L.-listed strain
relief to the hole below terminal block
opening. Strain relief should have a tight
fit with dryer cabinet and be in a horizon-
tal position. Put the direct wire cable
through the strain relief.
STEP 6. Place the hook-shaped end of
the wire over the terminal block screw.
The open side of the hook should face
to the right. Squeeze hook end of wire to-
gether to form a loop.
STEP 4. Remove the center terminal
block screw. Remove the neutral ground-
ing wire (green/yellow wire) from external
grounding screw.
External ground Center silver-colored
connector terminal block screw
Green/yellow wire
of harness
STEP 5. Connect neutral grounding wire
and the neutral wire (white or center) of
direct wire cable under the center screw
of terminal block.
STEP 7. Connect the other two wires
to outer terminal block screws. Use the
same method described in STEP 6.
STEP 8. Connect the direct wire cable
(bare) grounding wire to the external-
grounding conductor screw. Securely
tighten all electrical connections.
STEP 9. Tighten the strain relief screws.
STEP 10. insert tab of terminal block
cover into slot of the dryer rear panel.
Secure cover with hold-down screw.
External
ground
connector
\
\
Neutral wire
Center silver-colored
terminal block screw/(white)
/
//
Green wire /
of power supply
cord or bare
copper wire ¾-inch, U.L.-listed
strain relief
Neutral grounding
wire (green/yellow)
4-Wire Connection with Direct Wire
and Frame-Grounding Conductor
23