Kenmore 11069912990 Owner's Manual And Installation Instructions page 17

STEP 2.Remove hold-down screw and
terminal block c over.
Hold-down screw
\
STEP 4a. Place the hook-shaped end
of the wire over the terminal block screw.
The open side of the hook should face
to the right. Squeeze hook end of wire
together to form a loop.
Terminal block cover
STEP 3. Attach a _-inch, U.L.-Iisted strain
relief to the hole below terminal block
opening. Strain relief should have a tight
fit with dryer cabinet and be in a horizon-
tal position. Put the direct wire cable
through the strain relief.
STEP 4. Loosen or remove terminal block
screws. Connect the neutral wire (white or
center) of direct wire cable under the cen-
ter screw of the terminal block.
External ground
connector
STEP 5. Connect the other two wires to
outer terminal block screws using the
same method(s) described in STEP 4a.
Securely tighten all electrical connections.
STEP 6. Tighten the strain relief screws.
STEP 7. insert tab of terminal block cover
into slot of the dryer rear panel. Secure
cover with hold-down screw.
If local codes do not permit the
connection of a frame-grounding
conductor to the neutral wire,
see the instructions on page 18.
Otherwise, proceed with Installation
on page 24.
Center silver-colored
terminal block screw
Neutral wire
(white)
Neutral grounding /
wire (green/yellow)
K-inch, U.L.-listed
strain relief
3-Wire Connection with Direct Wire
and Frame-Grounding Conductor
I7