Lcd Messages - Canon 0860B001 User Manual

LCD Messages

The following messages are displayed in the LCD when the machine performs a function or if it
encounters an error.
This section describes the general messages and those related to copy and print functions. For the
messages related to fax functions, refer to Chapter 7, "Troubleshooting," in the Facsimile Guide.
ADJUSTING
WAITING TO SCAN
Cause
Remedy
CHECK DOCUMENT
Cause 1
Remedy
9
Cause 2
Remedy
CHECK PAPER SIZE
Cause
Remedy
9-24
The machine is not ready for copying because you have just connected the power cord to the
machine.
Please wait for a while (approx. 1 min.) till the working sound of the main unit stops. Scanning cannot
be performed for a while immediately after the power cable is connected.
There is a paper jam in the ADF.
Remove the document you are trying to copy in the ADF. (See "Removing Jammed Paper from the
ADF," on p. 9-23.)
Make sure that the document is not too long or too short. (See "Document Requirements," on p. 3-1.)
The ADF roller rotates without feeding documents.
Fan the edge that will feed into the machine first, then tap the edge of multiple page documents on a
flat surface to even the stack.
The size of the paper in the cassette or multi-purpose tray is different from that of the paper specified
in <PAPER SETTINGS> of the Menu.
Load the correct paper size or change <PAPER SIZE> in <PAPER SETTINGS> of the Menu. (See
"Loading Paper," on p. 2-3, or "Specifying the Paper Size," on p. 2-16.)
Then reset the machine by opening the cartridge cover and then closing it.