Rmon Messages - Cisco 3750 - Catalyst EMI Switch Message Manual

RMON Messages

Error Message QOSMGR-4-NOT_SUPPORTED: Action '[chars]' is not supported for a
policymap attached to output side.
Error Message QOSMGR-4-POLICER_PLATFORM_NOT_SUPPORTED: Policer configuration has
exceeded hardware limitation for policymap [chars].
Error Message QOSMGR-4-POLICER_POLICY_NOT_SUPPORTED: Number of policers has exceeded
per policy hardware limitation for policymap [chars].
RMON Messages
This section contains the remote network monitoring (RMON) messages.
Error Message RMON-5-FALLINGTRAP: Falling trap is generated because the value of
[chars] has fallen below the falling-threshold value [dec].
Catalyst 3750 Switch System Message Guide
2-66
Explanation This message means that a set or trust policy-map class configuration command was
configured in a policy map and attached to an egress interface. A warning message is logged, and
the actions do not take affect. This is a hardware limitation. [chars] is either the set or trust action.
Recommended Action Do not configure a set or trust policy-map class configuration command in a
policy map and attach it to an egress interface. These policy-map actions are supported only on
ingress interfaces.
Explanation This message means that the policy-map configuration has exceeded the limitation of
the hardware. You configured more policers together in all policy maps (by using the police or
police aggregate policy-map class configuration command) than supported by hardware. [chars] is
the policy-map name.
Reconfigure the class maps or the policy maps, or delete the policy map from
Recommended Action
some interfaces.
This message means that the policy-map configuration has exceeded the limitation of
Explanation
the hardware. You configured more policers in a policy map (by using the police or police aggregate
policy-map class configuration command) than supported. [chars] is the policy-map name.
Reconfigure the class map or the policy map, and reduce the number of
Recommended Action
policers.
Explanation This message means that a falling trap has been generated. The value of the specified
MIB object has fallen below the falling threshold value. [chars] is the MIB object, and [dec] is the
threshold value.
Take appropriate action on the specified MIB object.
Recommended Action
Chapter 2 Message and Recovery Procedures
78-16184-04