Cisco 3750 - Catalyst EMI Switch Message Manual page 83

Chapter 2 Message and Recovery Procedures
Error Message QOSMGR-4-CLASS_NOT_SUPPORTED: Classification is not supported in
classmap [chars].
Explanation
configured in a policy map and attached to an egress interface or that more than one match
class-map command was configured. This is a hardware limitation. [chars] is the class-map name.
Recommended Action
dscp-list class-map configuration command in a policy map that is attached to an egress interface.
Only one match per class map is supported.
Error Message QOSMGR-4-COMMAND_FAILURE: Execution of [chars] command failed.
Explanation
possibly due to lack of hardware resources. [chars] is the description of the command.
Recommended Action
indicate that the hardware resources are exceeded, retry the command with a smaller configuration.
Find out more about the error by using the show tech-support privileged EXEC command and by
copying the error message exactly as it appears on the console or system log and entering it in the Output
Interpreter tool. Use the Bug Toolkit to look for similar reported problems. For more information about
these online tools and about contacting Cisco, see the
page
Error Message QOSMGR-4-HARDWARE_NOT_SUPPORTED: Hardware limitation has reached for
policymap [chars].
Explanation
the hardware. You configured more QoS ACL entries than the number specified in the Switch
Database Management (SDM) template. [chars] is the policy-map name.
Recommended Action
ACLs.
Error Message QOSMGR-4-MATCH_NOT_SUPPORTED: Match type is not supported in classmap
[chars].
Explanation
access-group acl-index-or-name, ip dscp dscp-list, and ip precedence ip-precedence-list match
types are supported with the match class-map configuration command. [chars] is the class-map
name.
Recommended Action
and match ip precedence class-map configuration commands within the class map.
78-16184-04
This message means that an unsupported match class-map configuration command was
Reconfigure the class map or the policy map. Use only the match ip dscp
This message means that the command to configure a QoS setting failed. This is
Check if any other messages indicate resource failure. If other messages
1-5.
This message means that the policy-map configuration has exceeded the limitation of
Reconfigure the class map or the policy map, and reduce the number of QoS
This message means that an unsupported match type was entered. Only the
Reconfigure the class map; use only the match access-group, match ip dscp,
"Error Message Traceback Reports" section on
Catalyst 3750 Switch System Message Guide
QOSMGR Messages
2-65