Gbic_Security_Crypt Messages - Cisco 3750 - Catalyst EMI Switch Message Manual

GBIC_SECURITY_CRYPT Messages

Error Message GBIC_SECURITY-4-EEPROM_SECURITY_ERR: GBIC in [chars] failed security
check.
Error Message GBIC_SECURITY-4-GBIC_INTERR: Internal error occurred in setup for GBIC
interface [chars].
GBIC_SECURITY_CRYPT Messages
This section contains the Cisco GBIC module and SFP module security messages. The switch recognizes
the module as a Cisco module but identifies another problem with it.
Note The switch supports SFP modules and does not support GBIC modules. Although the error message text
refers to GBIC interfaces and modules, the messages from the switch actually refer to the SFP module
interfaces and modules.
Error Message GBIC_SECURITY_CRYPT-4-ID_MISMATCH: Identification check failed for
GBIC interface [chars].
Catalyst 3750 Switch System Message Guide
2-26
Explanation The GBIC in the specified port has invalid EEPROM data. [chars] is the port in which
the GBIC is inserted.
Recommended Action Remove the GBIC from the port.
Explanation This message means that the system could not allocate resources or had some other
problem during the setup for the specified SFP module interface. [chars] is the interface in which
the SFP module is installed.
Reload the switch by using the reload privileged EXEC command. If the
Recommended Action
problem persists, find out more about the error by using the show tech-support privileged EXEC
command and by copying the error message exactly as it appears on the console or system log and
entering it in the Output Interpreter tool. Use the Bug Toolkit to look for similar reported problems. For
more information about these online tools and about contacting Cisco, see the
Traceback Reports" section on page
This message means that the SFP module was identified as a Cisco SFP module, but the
Explanation
system was unable to verify its identity. [chars] is the interface in which the module is installed.
Recommended Action Check the list of supported SFP modules for this version of the system
software. An upgrade might be required for newer modules. Otherwise, verify that the module was
obtained from Cisco or from a supported vendor.
Chapter 2
1-5.
Message and Recovery Procedures
"Error Message
78-16184-04