Cfgmgr Messages - Cisco 3750 - Catalyst EMI Switch Message Manual

CFGMGR Messages

Error Message BSPATCH-1-PATCHED: Boot Loader patch ([chars]) installed.
Error Message BSPATCH-3-FAILED: Failed to install Boot Loader patch ([chars]).
CFGMGR Messages
This section contains the configuration manager messages.
Error Message CFGMGR-1-UNABLE_TO_SEND_RUN_CFG: unable to send running-cfg, bits:
[hex], retrying...
Catalyst 3750 Switch System Message Guide
2-8
This message means that a boot loader patch is installed successfully. [chars] is the
Explanation
SDRAM refresh timer register setting.
Recommended Action If this message recurs, copy it exactly as it appears on the console or in the
system log. Research and attempt to resolve the error by using the Output Interpreter. Use the Bug
Toolkit to look for similar reported problems. If you still require assistance, open a case with the
TAC, or contact your Cisco technical support representative, and provide the representative with the
gathered information. For more information about these online tools and about contacting Cisco, see the
"Error Message Traceback Reports" section on page
Explanation This message means that the switch failed to apply a boot loader patch. [chars] is the
SDRAM refresh timer register setting.
Copy the message exactly as it appears on the console or in the system log.
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
Message Traceback Reports" section on page
Explanation This message means that the system is unsuccessfully attempting to distribute the
running configuration to the stack member switches. [hex] is the bit representation of the switch
number.
Find out more about the error by using the show tech-support privileged
Recommended Action
EXEC command and by copying the error message exactly as it appears on the console or system
log and entering it in the Output Interpreter tool. Use the Bug Toolkit to look for similar reported
problems. For more information about these online tools and about contacting Cisco, see the
Message Traceback Reports" section on page
Chapter 2 Message and Recovery Procedures
1-5.
1-5.
1-5.
"Error
"Error
78-16184-04