Sdm Messages; Span Messages - Cisco 3750 - Catalyst EMI Switch Message Manual

Chapter 2 Message and Recovery Procedures
Error Message RMON-5-RISINGTRAP: Rising trap is generated because the value of
[chars] exceeded the rising-threshold value [dec].

SDM Messages

This section contains the Switch Database Management (SDM) message.
Error Message SDM-6-MISMATCH_ADVISE: [chars].

SPAN Messages

This section contains the Switched Port Analyzer (SPAN) messages.
Error Message SPAN-3-MEM_UNAVAIL: Memory was not available to perform the SPAN
operation.
Error Message SPAN-3-UNKN_ERR: An internal error occurred during a SPAN operation.
78-16184-04
Explanation This message means that a rising trap has been generated. The value of the specified
MIB object has exceeded the rising threshold value. [chars] is the MIB object, and [dec] is the
threshold value.
Recommended Action Take appropriate action on the specified object.
This message means that a stack member cannot support the SDM template that the
Explanation
stack master is using. Switches in the SDM mismatch state are not functional stack members. This
error follows the STACKMGR-6-SWITCH_ADDED_SDM error message if it reports
SDM_MISMATCH. [chars] displays mismatch information and recommended corrective actions.
Downgrade the SDM template of the stack master to make it compatible with
Recommended Action
the stack member switches. For example, if the stack master uses the aggregator routing template,
the message recommends downgrading the stack master to the desktop routing template by using the
sdm prefer vlan desktop global configuration command.
This message means that the system was unable to perform a SPAN operation because
Explanation
of a lack of memory.
Reduce other system activity to ease the memory demands.
Recommended Action
This message means that SPAN detected an error in its internal operation.
Explanation
Recommended Action The error might be transient. Try the SPAN operation again. If a second attempt
also fails, reload the switch by using the reload privileged EXEC command to complete the
operation.
Catalyst 3750 Switch System Message Guide
SDM Messages
2-67