Platform_Pbr Messages - Cisco 3750 - Catalyst EMI Switch Message Manual

Chapter 2 Message and Recovery Procedures

PLATFORM_PBR Messages

This section contains policy based routing (PBR) messages.
Error Message PLATFORM_PBR-2-NO_RMAP: Cannot create PBR data structures for
route-map [chars].
Error Message PLATFORM_PBR-3-INSTALL_FAIL: Policy route-map [chars] not installed in
hardware.
Error Message PLATFORM_PBR-3-NO_LABEL: Cannot allocate label for route-map [chars].
Error Message PLATFORM_PBR-3-UNSUPPORTED_RMAP: Route-map [chars] not supported for
Policy-Based Routing.
78-16184-04
This message means that the PBR manager could not allocate the internal data structures
Explanation
for this route-map. A likely cause is lack of available memory. [chars] is the route-map.
Simplify the configuration so that it requires less memory.
Recommended Action
This message means that the PBR manager was unable to install the complete route-map
Explanation
in hardware, so the packets are forwarded to the CPU for processing. [chars] is the route-map.
Recommended Action Simplify route-map configurations. For example, use the same route-map on
multiple interfaces.
This message means that the PBR manager could not allocate a label for this route-map.
Explanation
As a result, the hardware cannot be programmed to implement policy routing. There is a limit of 247
labels for policy routing. [chars] is the route-map.
Recommended Action Simplify the configuration with label sharing. Use the same route-maps on
multiple interfaces, if possible.
This message means that the route-map attached to an interface for policy routing
Explanation
contains an action that is not supported on this platform. This is a hardware limitation. [chars] is the
route-map.
Recommended Action Use the route-map map-tag permit global configuration command and the set
ip next-hop ip-address route-map configuration command to reconfigure the route map to use only
these supported actions.
PLATFORM_PBR Messages
Catalyst 3750 Switch System Message Guide
2-45