Starting The Cluster Configuration Tool - Red Hat CLUSTER SUITE - CONFIGURING AND MANAGING A CLUSTER 2006 Manual

40 Chapter 3. Installing and Configuring Red Hat Cluster Suite Software
To automatically install RPMs, follow these steps at each node:
1. Log on as the root user.
Note
The following steps specify using
Using the
lation of Red Hat Cluster Suite and Red Hat GFS. (Without the
up2date
2. Run
up2date --force --installall=channel-label
Suite. The following example shows running the command for i386 RPMs:
# up2date --force --installall=rhel-i386-as-4-cluster
3. (Optional) If you are installing Red Hat GFS, run
--installall=channel-label
running the command for i386 RPMs:
# up2date --force --installall=rhel-i386-as-4-gfs-6.1
Note
The preceding procedure accommodates most installation requirements. However, if your
installation has extreme limitations on storage and RAM, refer to Appendix B Selectively
Installing Red Hat Cluster Suite Packages for more detailed information about Red Hat
Cluster Suite and Red Hat GFS RPM packages and customized installation of those
packages.
3.4. Starting the Cluster Configuration Tool
You can start the Cluster Configuration Tool by logging in to a cluster node as root with
the command and issuing the
ssh -Y
ple, to start the Cluster Configuration Tool on cluster node nano-01, do the following:
1. Log in to a cluster node and run
$ssh -Y root@nano-01
.
.
.
option includes kernels that are required for successful instal-
--force
skips kernels by default.)
up2date installall
for Red Hat GFS. The following example shows
system-config-cluster
system-config-cluster
with the option.
--force
option,
--force
for Red Hat Cluster
up2date --force
command. For exam-
. For example: