Table of Contents
Advertisement
142
Appendix A. Supplementary Hardware Information
Use the appropriate SCSI cable to connect each host bus adapter to the storage enclosure.
•
Setting host bus adapter termination is done in the adapter BIOS utility during system boot.
To set RAID controller termination, refer to the vendor documentation. Figure A-3 shows
a configuration that uses two single-initiator SCSI buses.
Figure A-3. Single-initiator SCSI Bus Configuration
Figure A-4 shows the termination in a single-controller RAID array connected to two
single-initiator SCSI buses.
Figure A-4. Single-controller RAID Array Connected to Single-initiator SCSI Buses
Figure A-5 shows the termination in a dual-controller RAID array connected to two single-
initiator SCSI buses.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Red Hat CLUSTER SUITE - CONFIGURING AND MANAGING A CLUSTER 2006
Related Products for Red Hat CLUSTER SUITE - CONFIGURING AND MANAGING A CLUSTER 2006
- Red Hat CERTIFICATE 7.2 RELEASE NOTES
- Red Hat CERTIFICATE SYSTEM 7.2 - MIGRATION GUIDE
- Red Hat CERTIFICATE SYSTEM 7.1 - ADMINSISTRATOR
- Red Hat CERTIFICATE 7.3 RELEASE NOTES
- Red Hat CERTIFICATE SYSTEM 8 - DEPLOYMENT
- Red Hat CERTIFICATE SYSTEM 8 - AGENTS GUIDE
- Red Hat CERTIFICATE 8.0 RELEASE NOTES
- Red Hat CERTIFICATE SYSTEM 8.0 - ADMINISTRATION
- Red Hat CERTIFICATE SYSTEM ENTERPRISE - SECURITY GUIDE
- Red Hat CLUSTER MANAGER - INSTALLATION AND
- Red Hat Application Server
- Red Hat APPLICATION SERVER - JONAS
- Red Hat APPLICATION STACK 1.1 RELEASE
- Red Hat APPLICATION STACK 1.2 RELEASE
- Red Hat APPLICATION STACK 1.3 RELEASE
- Red Hat APPLICATION STACK 1.4 RELEASE
Need help?
Do you have a question about the CLUSTER SUITE - CONFIGURING AND MANAGING A CLUSTER 2006 and is the answer not in the manual?
Questions and answers