Starting The Piranha Configuration Tool Service; Sshd Service - Red Hat CLUSTER SUITE - CONFIGURING AND MANAGING A CLUSTER 2006 Manual

Chapter 8. Initial LVS Configuration
If the password is changed during an active Piranha Configuration Tool session, the
administrator is prompted to provide the new password.
8.3. Starting the Piranha Configuration Tool Service
After you have set the password for the Piranha Configuration Tool, start or restart the
service located in
piranha-gui
the following command as root:
/sbin/service piranha-gui start
or
/sbin/service piranha-gui restart
Issuing this command starts a private session of the Apache HTTP Server by calling the
symbolic link
/usr/sbin/piranha_gui -> /usr/sbin/httpd
the
piranha-gui
fact that
piranha-gui
1. The Apache HTTP Server must be installed on the system.
2. Stopping or restarting the Apache HTTP Server via the
piranha-gui
Warning
If the command
sued on an LVS router, you must start the
command:
/sbin/service piranha-gui start
The
piranha-gui
However, if you are configuring the cluster remotely, the
do not need to start the
Tool is complete. See Section 10.8 Starting the Cluster for information on starting the
service.
pulse
/etc/rc.d/init.d/piranha-gui
version of runs as the piranha user in a separate process. The
httpd
leverages the
httpd
service.
/sbin/service httpd stop
service is all that is necessary to begin configuring an LVS cluster.
service until configuration using the Piranha Configuration
pulse
service means that:
service
or
/sbin/service httpd restart
service by issuing the following
piranha-gui
service is also required. You
sshd
. To do this, type
. For security reasons,
command stops the
is is-
99