Air Purge; Installer Settings; To Perform A Test Run - Daikin Altherma H Hybrid EJHA04AAV3 Installer's Reference Manual

To perform an automatic air purge
To interrupt air purge

13.4.2 To perform a test run

EJHA04AAV3 + EHY2KOMB28+32AA
Daikin Altherma H Hybrid
4P531180-1D – 2025.03

Air purge

Speed Low
Circuit SHC
Stop Adjust
5 Use the and buttons to set the desired pump speed.
Result: Low
Result: High
6 If applicable, set the desired position of the 3-way valve (space heating/
domestic hot water). Use the and buttons to scroll to Circuit.
7 Use the and buttons to set the desired position of the 3-way valve.
Result: SHC or Tank
INFORMATION
Frost protection functions. After first power-on, the unit runs in "installer-on-site"
mode (see "13.3 Checklist before
mode ends, the unit's frost protection functions are enabled, and you cannot start
the air purge function if Ta<4°C.
Prerequisite: Make sure that the leaving water temperature home page, room
temperature home page, and domestic hot water home page are turned OFF.
1 Set the user permission level to Installer. See
4
to Installer" [ 137].
2 Set the air purge mode: go to [A.7.3.1]
Commissioning > Air purge > Type.
3 Select Automatic and press
4 Go to [A.7.3.4]
purge > Start air purge and press
Result: Air purging will start and the following screen will be shown.
Air purge
Speed
Low
Circuit SHC
Stop Adjust
1 Press and press
Prerequisite: Make sure that the leaving water temperature home page, room
temperature home page, and domestic hot water home page are turned OFF.
1 Set the user permission level to Installer. See
4
to Installer" [ 137].
2 Go to [A.7.1]: > Installer settings > Commissioning > Test run.
3 Select a test and press
01:18
Tue
Scroll
commissioning" [
.
> Installer settings > Commissioning > Air
to start the air purge function.
Tue 01:18
Scroll
to confirm the interruption of the air purge function.
. Example: Heating.
13 Commissioning
|
4 186]). When "installer-on-site"
"To set the user permission level
> Installer settings >
"To set the user permission level
Installer reference guide
189