Figure 18. Intel® Raid Module Placement And Installation - Intel RMSP3AD16OF Hardware User's Manual

Intel® RAID Modules RMSP3AD160F, RMSP3CD080F and RMSP3HD080E Hardware User Guide
7. Install the SAS and / or SATA drives in the host computer case. Refer to the documentation for the devices
for any pre-installation configuration requirements.
8. Connect the internal SAS / SATA data cables to appropriate drives/backplane/or expander card.
9. If NVMe drives are to be used, connect the AXXCBL700HDCV cable to the appropriate backplane.
10. Carefully route the SAS / SATA / NVMe data cables back to the Intel® RAID Module.
11. Attach the SAS/SATA / NVMe data cables to the Intel® RAID Module.
12. Reinstall the computer cover, and reconnect the AC power cords to the system.
The hardware installation is now complete and the Intel® RAID Module is ready to be configured. For
complete Intel® RAID Module configuration information, refer to the Intel® RAID Software User Guide for full
featured and entry level RAID controllers available to download from the following Intel website:
http://www.intel.com/support.
NOTE: The Intel Tri-Mode modules are designed to work on systems configured for optimized UEFI boot
mode. There is no built-in configuration utility for these modules when the system is configured for legacy
boot mode. Some modules like RMSP3HD080E will not work when the system they are installed on is
configured for legacy boot mode.
Figure 18. Intel® RAID module placement and installation
36