OPTICOM 4 CHANNELS MPEG-4 DIGITAL VIDEO RECORDER - V 1.2 Instruction Manual page 43

4 channels mpeg-4 digital video recorder
Table of Contents

Advertisement

Setting of CHANNEL - Select CHANNEL to set the recording setting as bellows using
FRAME RATE – Set the frame rate value using
The total frame rate when resolution is 704X480(NTSC) / 704X576(PAL): 30 / 25
The total frame rate when resolution is 352X240 (NTSC) / 352X288(PAL): 120 / 100
QUALITY – Select the quality of the recording video using
Setting values: NORMAL, HIGH, SUPER
RECORDING – Select the recording mode using
CONTINOUS: The input video is recorded when the DVR is turned ON.
BY MOTION: The input video is recorded when the motion is detected.
BY SENSOR: The input video is recorded when the external sensor is activated.
BY SCHEDULE: The input video is recorded according to SCHEDULE setting.
DISABLE: The input video is NOT recorded.
MOTION ZONE – Select the motion zone type using
FULL ZONE: The motion on the whole screen is detected.
PARTIAL ZONE: The motion on the pre-set detection grid is detected.
MOTION SENSITIVITY – Set the level of motion detection sensitivity using
Setting values of the display bar: 1 / 2 / 3 ~ 7 / 8 / 9 (Low sensitivity level)
SENSOR TYPE – Select the external sensor type using
---: No operation
N/O: Normal open type sensor
N/C: Normal close type sensor
PRE RECORD – Select ON/OFF of the pre-recording on the event using
ON: The 1ips of video for 5 seconds is recorded before the event (motion detection or
sensor activation).
OFF: No pre-recording.
POST EVENT RECORD – Set the recording time after the event using
Setting values: 2 / 3 / 4 ~ 27 / 28 / 29 / 30 seconds
ALARM – Select ON/OFF of the alarm output using
ON: The alarm trigger signal is sent to the external alarm when the event is detected.
OFF: The alarm trigger signal is NOT sent to the external alarm when the event is detected.
ALARM DURATION – Select the length of alarm signal output using
Setting values: 1 / 2 / 3 / 4 ~ 57 / 58 / 59 / 60 seconds
AUDIO – Select ON/OFF of the audio recording using
ON: The audio is recorded.
OFF: The audio is NOT recorded.
SCHEDULE – Set the recoding schedule of each channel.
buttons.
▶◀
buttons.
▶◀
buttons.
▶◀
buttons.
▶◀
buttons.
▶◀
buttons.
▶◀
buttons.
▶◀
43
buttons
▶◀
buttons.
▶◀
buttons.
▶◀
buttons.
▶◀
buttons.
▶◀

Advertisement

Table of Contents
loading

This manual is also suitable for:

4 mpeg-4 1.2

Table of Contents