Table of Contents
Advertisement
3-1. MOTION DETECTION recording
A motion detection setting is available for each channel.
①
Set the basic record menu using the direction buttons before setting Motion detection.
RESOLUTION
CHANNEL:
FRAME RATE
QUALITY
Upon Motion detection, the DVR records input video with these setting.
②
To select a channel for motion detection recording, go to CHANNEL filed using ▲▼ button and select a
channel from CH1, CH2, CH3, and CH4 using
③
Go to RECORDING filed using ▲▼button and select BY MOTION using
④
Go to MOTION ZONE filed using ▲▼button and select PARTIAL ZONE using
When FULL ZONE is selected, the DVR detects a motion from whole video screen. Set only MOTION
SENSITIVITY.
⑤
Select the grids for motion detection using ▲▼
displayed in Pink color.
⑥
Go to MOTION SENSITIVITY using ▲▼ button and select the sensitivity using
Sensitivity grade: 1 –The highest sensitivity against motion
⑦
Go to PRE RECORD using ▲▼ button and select ON or OFF as necessary using
When PRE RECORD is ON, the DVR records 1 fps for 5 seconds before any motion detection.
⑧
Go to POST EVENT RECORD using ▲▼ button and select the time as necessary using
The available POST EVENT RECORD time: 2 to 30 seconds.
⑨
Repeat this step to set the other channel as necessary.
⑩
Go to SAVE SETUP using ESC button and save the setting.
9 – The lowest sensitivity against motion
button.
▶◀
button and SEL button. Then the selected grids are
▶◀
23
button.
▶◀
button.
▶◀
button.
▶◀
button.
▶◀
button.
▶◀
Advertisement
Table of Contents
