Continous Recording; Sensor Recording - OPTICOM 4 CHANNELS MPEG-4 DIGITAL VIDEO RECORDER - V 1.2 Instruction Manual

3-2. CONTINOUS recording

CONTINOUS recoding setting is available for each channel. The DVR records automatically input video in
CONTINOUS recording mode as a factory default, unless RECODING mode is changed.
①
Set the basic record menu using ▲▼
RESOLUTION
CHANNEL
FRAME RATE
QUALITY
Upon connecting cameras, the DVR records input video displaying C on the screen.
②
To stop CONTINOUS recording of each channel, go to CHANNEL filed using ▲▼ button and select a
channel from CH1, CH2, CH3, and CH4 using
③
Go to RECORDING filed using ▲▼button and select DISABLE using

3-3. SENSOR recording

Sensor is connected to each channel and be used a recording trigger.
①
Connect a sensor to an sensor terminal on the rear of the DVR.
②
Set the basic record menu using ▲▼
RESOLUTION
CHANNEL
FRAME RATE
QUALITY
Upon sensor sends a signal to the DVR, the DVR records input video displaying S on the screen.
③
To select a channel for sensor triggered recording, go to CHANNEL filed using ▲▼ button and select a
channel from CH1, CH2, CH3, and CH4 using
④
Go to RECORDING filed using ▲▼button and select BY SENSOR using
⑤
Go to SENSOR TYPE using ▲▼ button and select the type of sensor using
⑥
Go to PRE RECORD using ▲▼ button and select ON or OFF as necessary using
⑦
Go to POST EVENT RECORD using ▲▼ button and select the time as necessary using
⑧
Repeat this step to set the other channel as necessary.
⑨
Go to SAVE SETUP using ESC button and save the setting.
Alarm time setting on activation of motion detection or sensor
When motion detection or sensor is activated, a relay signal triggers the external alarm device.
①
Connect an external alarm device to the alarm out terminal
②
To select a channel for alarm output upon an activation of motion detection or sensor, go to CHANNEL
filed using ▲▼ button and select a channel from CH1, CH2, CH3, and CH4 using
③
Go to ALARM filed using ▲▼button and select ON or OFF as necessary using
④
Go to ALARM DURATION using ▲▼ button and select the time as necessary using
⑤
Repeat this step to set the other channel as necessary.
⑥
Go to SAVE SETUP using ESC button and save the setting.
buttons before setting Motion detection.
▶◀
button.
▶◀
buttons before setting Sensor recording.
▶◀
button.
▶◀
(Refer to page 17)
24
button.
▶◀
(Refer to page 17)
button.
▶◀
button.
▶◀
▶◀
button.
▶◀
button.
▶◀
▶◀
button.
button.
▶◀
button.