Record - OPTICOM 4 CHANNELS MPEG-4 DIGITAL VIDEO RECORDER - V 1.2 Instruction Manual

6-2. RECORD

Menu item
RESOLUTION
CHANNEL
FRAME RATE
QUALITY
RECORDING
MOTION ZONE
MOTION SENSITIVITY
SENSOR TYPE
PRE RECORD
POST EVENT RECORD
ALARM
ALARM DURATION
AUDIO
SCHEDULE
RESOLUTION – Select the resolution for the recording using
352x240: The input video is recorded as 352x240 resolution.
704x480: The input video is recorded as 704x480 resolution.
The resolution setting is applied to every channel.
Set resolution to either
704x480(NTSC)/704X576(PAL) or 352x240(NTSC)/352X288(PAL).
Select the channel for applying the following settings.
Set the frame rate for the specified channel.
The sum of the frame rate values from each channel cannot exceed maximum
frame rates for a particular recording resolution.
The maximum frame rate: 120/100fps - 352x240(NTSC)/352X288(PAL)
Select the recording quality for the specified channel.
Assign the recording mode for each channel. Recording modes: Continuous,
Motion, Sensor, Schedule, and Disable.
Select Full Zone or Partial Zone for motion sensing.
Set the motion sensitivity for the specified channel.
Set the type of sensor for the specified channel from none,
N/O (normal open), and N/C (normal closed).
Enable/disable pre-event recording. Pre-event recording time is 5 sec and
only intra-frames are recorded for pre-event recording.
Set post event recording time duration for the specified channel
Enable/disable alarm generation for the specified channel.
Set alarm time duration for the specified channel.
Enable/disable audio for the specified channel
Set recording schedule.
Description
30/25 fps - 704x480(NTSC)/704X576(PAL)
buttons.
▶◀
42