Removing The Seat; Positioning Of The Child - BESAFE IZI COMFORT User Manual

5-
Put the shoulder belt through the
belt clamps. Make sure the belt is
not twisted (4).
6-
Push the seat firmly into the car
seat.
7- Tight installation is most important
for forward facing seats.
Tension the belts as follows:
Pull the shoulder belt upwards (A).
Have a firm grip on the shoulder
belt in the seat area (B). Close the
clamp on the inner side (C).
Pull upper belt part on the door
side and close clamp D (4).
8-
Push the belt tensioner in the
arrow direction to tension the
3-point car belt (5).
9-
Make sure the 3-point car belt is as tight as possible.
Repeat the procedure if the car belt is not tight.
10-
Push the head rest in the correct position (refer to
'Positioning of the child' on page 7). The seat is now ready
to use.
6
D
C
B
A
(4)
(5)

Removing the seat

1- Loosen the tension in the car belt by releasing the belt
tensioner.
2- If the seat is installed in the back seat of the vehicle, push
the front seat of the vehicle forward as much as possible.
3-
Unlock the belt clamps and unlock the car belt.
4- Remove the car belt and remove the seat from the vehicle.

Positioning of the child

1- Position of the shoulder straps: Check that
the shoulder strap slots are levelled with your
child's shoulders (6).
2- The height of the shoulder
straps and the head rest can be
adjusted by releasing the release
handle at the back of the head
rest and pulling the head rest up
or down while keeping the head
rest upright (7).
(6)
too high
too low
correct
(7)
7 7