MACROMEDIA COLDFUSION 5-ADVANCED ADMINISTRATION Manual page 173

Processing Options
By default, a document checksum is computed based on the CRC-32 algorithm. The
checksum combined with the document size is used to determine if the document is
a duplicate.
See also -followdup.
-noindex
Specifies that the Verity Spider gathers document locations without indexing them.
The document locations are stored in a bulk insert file (BIF), which is then submitted
to the collection. This option is typically used in conjunction with a separate
indexing process, such as
processed by the next indexing process run for the collection, whether it is the Verity
Spider,
Do not try to start both the Verity Spider and another process at the same time. You
must allow Verity Spider enough time to generate enough work for the secondary
indexing process to act upon. If you are using
mode to ensure it will act upon work generated by Verity Spider.
Note
When you execute an indexing job for a collection and you use
persistent store for the collection is not updated.
See also
For more information on
mkvdk Utility" on page
-nosubmit
Specifies that the Verity Spider gathers document locations without indexing them.
The document locations are stored in a bulk insert file (BIF), which is not submitted
to the collection. This option is typically used in conjunction with a separate
indexing process, such as
Verity Spider again with the -processbif option. Note that with an indexing process
other than Verity Spider, you must specify the name and path for the BIF because the
collection has no record of it.
-persist
Syntax:
Enables the Verity Spider to run in persistent mode, checking for updates every
num_seconds
While the Verity Spider is running in persistent mode, there is no optimization. Once
the Verity Spider is taken out of persistent mode, you will need to perform
optimization on the collection. For more information about using
"Managing Verity Collections with the mkvdk Utility" on page
mkvdk
or collection servicers (
mkvdk
-nocache and -nosubmit.
mkvdk
185.
mkvdk
-persist num_seconds
seconds until it is stopped.
or collection servicers (
).
collsvc
mkvdk
, see Chapter 9, "Managing Verity Collections with the
or collection servicers (
). The BIF will be
collsvc
, you can run it in persistent
-noindex
). You can also use
collsvc
mkvdk
185.
155
, the
Chapter 9,