Configuring Coldfusion Probes In Unix - MACROMEDIA COLDFUSION 5-ADVANCED ADMINISTRATION Manual

Session-Aware Load Balancing
6
7
Removing ColdFusion probes
To remove a ColdFusion probe:
1
2
3

Configuring ColdFusion probes in UNIX

This section describes the following:
Adding ColdFusion probes
To add a new ColdFusion probe:
1
2
3
4
5
6
7
Click Register to create the probe.
Close all open dialog boxes.
An icon for the new probe appears under the Monitor Manager in the
ClusterCATS Explorer.
Open the ClusterCATS Explorer.
Select the cluster_name > Monitor Manager > monitor_name > probe_name in
the left pane.
Select Probe > Delete. Alternatively, you can right-click the probe and select
Delete.
"Adding ColdFusion probes" on page 285
"Editing and removing ColdFusion probes" on page 288
Open the ClusterCATS Web Explorer if it is not already open.
Click the Show Cluster link. The Show Cluster page appears.
In the Web Server Name field, enter the fully qualified host name of the server for
which you want to configure the ColdFusion probe.
Click OK. The Cluster Member List page appears.
Click the Server Attributes link. The Connect To Server page appears.
Select the server you want to add a probe to from the Web Server Name listbox.
Click OK. The selected server's Properties page appears.
285