Zone Setup - Russound CAV66 2 Instruction Manual

Source Select Command (cont'd)
2. COMMAND TYPE (f) –
a. Selected: Learned IR
i. LEARNED SRC (f) –
b. Selected: Unassigned
c. Selected: Default
d. Selected: Macro:
i. MACRO -
ii. MACRO ID –
e. All Other Selections:
3. DEVICE CODE (f) –
4. KEY FUNCTION (f) –
5. SAVE CHANGES? (f) –
# OF SOURCES (f)
At this field it is necessary to enter the number of sources used in the CAV6.6 system (1 to 6). This
limits the sources displayed on the keypad in the normal running mode when the source button is
pressed, but also limits source selections in the configuration menus. See Source Setup Menu on
Page 48 and Source Select Command & # Of Sources - Flow Chart on page 63
ZONE SETUP (m)
NOTE: This procedure should be performed using the keypad installed in the zone to be configured.
See Installation Menu on Page 48 and Zone Setup - Flow Chart on page 64
Zone Setup allows the installer to adjust properties of the UNO Keypad controlled CAV6.6 zone. This
series of menus allows the system's zones to be configured for these properties:
ZON VOL TRIM SYSON ENABLE
PAGE VOLUME
Select the type of source command (e.g., CD, TV, etc.).
Choose Learned IR if the pre-programmed IR code library does
not support the source component.
Select the learned source bank to be assigned to the source
component. Procedure advances to KEY FUNCTION (step 4)
The source select command is cleared. Procedure advances to
SAVE CHANGES (step 5)
Default selects the same device type and device code previously
setup in BASIC SETUP. Procedure advances to KEY FUNCTION
(step 4)
(To build macros, see Macro Editor page 57)
Macro loads a series of commands which are processed when
activated.
Enter the macro ID number. Menu advances to SAVE CHANGES
(step 5)
Procedure advances to DEVICE CODE (step 3)
Source component code for IR control.
Select a function (Play, Enter, etc.).
Select "yes" to save the changes.
PARTY ENABLE
INSTALLER
INSTALLATION MENU
MASTER ENABL PAGE ENABLE
53