Russound CAV66 2 Instruction Manual page 50

INSTALLER
INSTALLATION MENU
Key Config (cont'd.)
5. KEY NAME (f) –
6. COMMAND TYPE (f) –
a. Selected: Learned IR –
i. LEARNED SRC (f) –
b. Selected: Unassigned
c. Selected: Default
d. Selected: Macro:
i. MACRO -
ii. MACRO ID –
e. All Other Selections:
7. DEVICE CODE (f) –
8. KEY FUNCTION (f) –
9. SAVE CHANGES? (f) –
SOURCE NAMES (p)
This procedure allows the installer to customize the source names for the sources attached to the
CAV6.6. See Source Setup Menu on Page 48 and Source Names/Vol Trim - Flow Chart on
page 61
1. SOURCE NUM (f) –
2. SOURCE NAME (f) –
50
Name that appears on the keypad display when the command is
activated.
Select the type of source command (e.g., CD, TV, etc.).
Choose Learned IR if the pre-programmed IR code library does
not support the source component.
Select the learned source bank to be assigned to the source
component. Procedure advances to KEY FUNCTION (step 8)
The key configuration is cleared. Procedure advances to SAVE
CHANGES (step 9)
Default selects the same device type and device code previously
setup in BASIC SETUP. Procedure advances to KEY FUNCTION
(step 8)
(To build macros, see Macro Editor page 57)
Macro loads a series of commands which are processed when
activated.
Enter the macro ID number. Menu advances to SAVE CHANGES
(step 9)
Procedure advances to DEVICE CODE (step 7)
Enter source component code number listed in this manual's
Reference section.
Select a function for the button.
Select "yes" to save changes. Procedure advances to ZONE NUM
(step 1)
Select the source number this name will be assigned to.
Select the name. SOURCE NUM will reappear on the LCD panel;
repeat the instructions for each source to be labeled.