Table of Contents
Advertisement
There are three item types in the installation menu:
Menu Item (m) – Acts as a folder that holds procedures and/or feature parameters.
Procedure (p) –
A sequence of feature parameters to perform a guided operation, such as
configuring an UNO key. Once you begin a procedure, the system will prompt for
the needed information to complete the task.
Feature (f) –
The actual parameters (settings) that will change the system configuration.
The following keys are used to navigate and make changes while using the installation menus:
To enter the Installation Menu, press and release the Setup Button (located on the keypad's right
side) while in normal operating mode. The Setup Button is used to "back out" of the Installation Menu
one level at a time. If you are performing a procedure, the Setup Button brings you back to the
beginning of the procedure. Once you have reached the top level of the Installation Menu, pressing
the Setup Button brings you back to normal operating mode.
Adjust feature setting (increment).
Adjust feature setting (decrement).
Go to next menu / procedure / feature. Not available while performing a procedure.
Go to previous menu / procedure / feature. Not available while performing a procedure.
Enter menu / begin procedure / show current feature setting. While performing a procedure, it is
also used to advance to the next sequential feature setting once the current feature has been viewed
or adjusted.
INSTALLER
INSTALLATION MENU
47
Advertisement
Table of Contents
