Advanced Options Using The Fwconfigure Command - Brocade Communications Systems 8 Administrator's Manual
Supporting fabric os v6.4.0
Hide thumbs
Also See for 8:
- Command reference manual (1080 pages) ,
- Reference (842 pages) ,
- Reference manual (382 pages)
Table of Contents
Advertisement
A
Advanced options using the fwConfigure command
13. Select apply threshold boundary changes by entering 9 at the Select choice = > prompt.
14. Enter until you reach the switch command prompt.
Advanced options using the fwConfigure command
During your planning activities, you should determine which elements or monitors you want to
configure, and in which class they reside.
NOTE
Not all areas allow for the customization of all fields. If you attempt an illegal modification, Fabric
Watch displays an error message. Ensure that all changes to the threshold and event setting areas
of the screen are confirmed before leaving advanced configuration, or the changes are lost.
The area menu displays five options.
Enter 4 at the Select choice => prompt, for a list of advanced configuration options.
Table 32
menu. With the exception of the last option, which exits advanced configuration mode, each option
has a similar behavior. For each option, one or two lines will appear, prompting you to accept the
new setting information, and, after the information has been provided, the entire screen will
refresh to display the updated information.
112
1
: change behavior type
2
: change behavior interval
3
: change threshold boundary level
4
: change custom unit
5
: change custom time base
6
: change custom low
7
: change custom high
8
: change custom buffer
9
: apply threshold boundary changes
10 : cancel threshold boundary changes
Select choice => : (1..18) [18] 9
1 : refresh
2 : disable a threshold
3 : enable a threshold
4 : advanced configuration
5 : return to previous page
describes the customization options displayed at the end of the Advanced Configuration
11 : change threshold alarm level
12 : change changed alarm
13 : change below alarm
14 : change above alarm
15 : change inBetween alarm
16 : apply threshold alarm changes
17 : cancel threshold alarm changes
18 : return to previous page
Fabric Watch Administrator's Guide
53-1001770-01
Advertisement
Table of Contents
