Cisco QuickVPN - PC Administration Manual page 61

Wireless-n gigabit security router with vpn
Hide thumbs Also See for QuickVPN - PC:
Table of Contents

Advertisement

Setting Up and Configuring the WRVS4400N Wireless-N Router
Setting Up Your Wireless-N Router
Cisco WRVS4400N Wireless-N Gigabit Security Router with VPN Administration Guide
Server Settings (DHCP)—Unless you already have a DHCP server, it is
highly recommended that you leave the router enabled as a DHCP server.
To use the router as your network's DHCP (Dynamic Host Configuration
Protocol) server, so that it automatically assigns an IP address to each
personal computer on your network, Enable DHCP server. (DHCP is
enabled by default.)
If you already have a DHCP server on your network, or you don't want a
DHCP server, then select Disable (no DHCP features will be available).
If you already have a DHCP server on your network, but you want the router
to act as a relay for that DHCP Server, select DHCP Relay, then enter the
DHCP Server IP address.
-
Starting IP Address—Enter a value for the DHCP server to start with
when issuing IP addresses. This value automatically follows your local IP
address settings.
-
Normally, you would assign the first IP address for the router (for example,
192. 1 68. 1 . 1 ) so that you can assign an IP address to other devices starting
from the 2nd IP address (for example, 192. 1 68. 1 .2).
-
The last address in the subnet is for subnet broadcast (for example,
192. 1 68. 1 .255) so that the address cannot be assigned to any host.
-
Maximum Number of DHCP Users—Enter the maximum number of
personal computers to which you want the DHCP server to assign IP
addresses.
-
This number cannot be greater than the available host addresses in the
subnet (for example, 253 for /24 subnet).
-
In order to determine the DHCP IP address range, add the starting IP
address (for example, 100) to the number of DHCP users.
-
Client Lease Time—Enter the amount of time you want a DHCP client to
keep the assigned IP address before it sends a renewal request to the
DHCP server. The default value is 0, which actually means one day.
-
Static DNS 1-3—If applicable, enter the IP address(es) of your DNS
servers.
5
61

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wrvs4400n

Table of Contents