Configuring The Key Management Settings; Configuring The Key Management Settings For Vpn Router 1 - Cisco QuickVPN - PC Administration Manual

Configuring a Gateway-to-Gateway IPSec Tunnel

Configuring the Key Management Settings

Configuring the Key Management Settings
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
STEP 8
STEP 9
STEP 10
STEP 11
STEP 12
STEP 13
STEP 14
STEP 15
Cisco WRVS4400N Wireless-N Gigabit Security Router with VPN Administration Guide
• "Configuring the Key Management Settings for VPN Router 1" on page
214
• "Configuring the Key Management Settings for VPN Router 2" on page
215

Configuring the Key Management Settings for VPN Router 1

Following these instructions for VPN Router 1.
On the IPSec VPN window, select 3DES from the Encryption drop-down menu.
Select MD5 from the Authentication drop-down menu.
Keep the default Key Exchange Method, Auto (IKE).
Select Pre-Shared Key, and enter a string for this key (for example, 13572468).
For the PFS setting, select Enabled.
If you need more detailed settings, click the Advanced Settings button.
Otherwise, click the Save Settings button and proceed to the next section,
"Configuring the Key Management Settings for VPN Router 2" on page
On the Advanced VPN Tunnel Setup window, keep the default Operation Mode,
Main.
For Phase 1, select 3DES from the Encryption drop-down menu.
Select MD5 from the Authentication drop-down menu.
Select 1024-bit from the Group drop-down menu.
Enter 3600 in the Key Life Time field.
For Phase 2, the Encryption, Authentication, and PFS settings were set on the
window. Select 1024-bit from the Group drop-down menu.
Keep the default Key Life Time value, 28800.
Click the Save Settings button on the Advanced VPN Tunnel Setup window.
Click the Save Settings button on the IPSec VPN window.
C
215.
VPN
214