Cisco QuickVPN - PC Administration Manual page 117

Setting Up and Configuring the WRVS4400N Wireless-N Router
Configuring the VPN Settings
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
Cisco WRVS4400N Wireless-N Gigabit Security Router with VPN Administration Guide
Configure the settings in the following sections of the VPN > IPSec VPN window:
• "Setting Up Local Groups" on page 118
• "Setting Up and Configuring Remote Groups" on page 119
• "Setting Up IPSec" on page 121
To configure advanced settings, click Advanced.
• Aggressive Mode—There are two types of Phase 1 exchanges: Main mode
and Aggressive mode. Aggressive Mode requires half of the main mode
messages to be exchanged in Phase 1 of the SA exchange. If network
security is preferred, select Main mode.
• NetBIOS broadcast—Check the box to enable NetBIOS traffic to pass
through the VPN tunnel. By default, WRVS4400N blocks these broadcasts.
Click Save.
To establish a connection for the current VPN tunnel, click Connect.
To break the connection, click Disconnect.
To view the VPN log, which shows details of each tunnel established, click View
Log.
5
117