Cisco QuickVPN - PC Administration Manual page 193

Troubleshooting
STEP 3
STEP 4
STEP 5
STEP 1
STEP 2
STEP 3
STEP 4
Cisco WRVS4400N Wireless-N Gigabit Security Router with VPN Administration Guide
Enter the IP Address of the server that you want the Internet users to access. For
example, if the web server's Ethernet adapter IP address is 192. 1 68. 1 . 1 00, you
would enter 100 in the field provided. Then check the Enable checkbox for the
entry. Consider the examples below:
Application Start and End
UT 7777 to 27900
Halflife 27015 to 27015
PC Anywhere 5631 to 5631
VPN IPSEC
Configure as many entries as you like.
When you have completed the configuration, click Save Settings.
I forgot my password or the password prompt always appears when
saving settings to the router.
Reset the router to factory defaults by pressing the Reset button for ten seconds
and then releasing it. If you are still getting prompted for a password when saving
settings, then perform the following steps:
Access the router's web interface by going to http://192. 1 68. 1 . 1 or the IP address
of the router. Enter the default password admin, and click Administration >
Management.
Enter the old password in the Old Password field.
Enter a different password in the New Password field, and enter the new
password in the Confirm New Password field to confirm the password.
Click Save Settings.
Protocol
Both
Both
UDP
500 to 500 UDP
IP Address Enable
192. 1 68. 1 . 1 00
192. 1 68. 1 . 1 05
192. 1 68. 1 . 1 02
192. 1 68. 1 . 1 00
A
X
X
X
X
193