Installation To Concrete Ceilings - Epson ELPMBPJF - Universal Projector Ceiling Mount Installation And Assembly Manual

Installation to Concrete Ceilings

• Concrete must be 2000 psi density minimum. Lighter density concrete may not hold concrete anchor.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached hard-
ware and components.
1
NOTE: ACC203 (Alligator concrete anchors are not
included) are recommended.
Drill two 1/4" (6 mm) dia. holes to a minimum depth of
2.5" (64 mm). Attach ceiling plate (G) using two concrete
anchors and #14 x 2.5" wood screws (F) as shown in
Illustration A and 1, 2 and 3. Tighten all fasteners.
IMPORTANT: It is the responsibility of the installer to
verify that the ceiling will safely support the
combined load of all attached hardware and
components.
Skip to step 2.
WARNING
• Tighten wood screws so that wall plate is firmly
attached, but do not overtighten. Overtightening can
damage the screws, greatly reducing their holding
power.
• Never tighten in excess of 80 in • lb (9 N.M.).
WARNING
• FOR DIRECT ATTACHMENT TO LOAD BEARING
CONCRETE ONLY! Concrete expansion anchors are
not intended for attachment to concrete ceilings
covered with a layer of plaster, drywall, or other
finishing material. If mounting to concrete ceiling
covered with plaster / drywall is unavoidable, plaster /
drywall must be counterbored as shown below.
INCORRECT
metal
concrete
bracket
plaster/
dry wall
Visit the Peerless Web Site at www.peerlessmounts.com
WARNING
CORRECT
metal
bracket concrete
plaster/
dry wall
6 of 10
For Technical Support Contact Peerless Mounts at 1-800-729-0307 or 708-865-8870.
1
Drill holes and insert anchors
2
Place ceiling plate over anchors and secure with screws
3
Tighten all fasteners
CONCRETE
CONCRETE CEILING
ANCHOR
G
F
Illustration A
ISSUED: 01-23-07 SHEET #:055-9498-2 05-29-08
concrete
surface
concrete
anchor
G
concrete
F
anchor