HP P5389A - Intel Pentium III-S 1.4 GHz Processor Upgrade Installation Manual page 11

the Platform Specific Module. Hot Plug support module may optionally display
depending on whether or not your HP NetServer supports Hot Plug PCI.
17. Under Driver names ensure that you see the same instances of drivers as controllers
in your system. If you are using any HP NetRAID series adapter, ensure that you see
the same instances of drivers as adapters in your system.
18. If there are drivers missing, use Options to add the missing drivers. Otherwise,
highlight Continue and press Enter.
NOTE: HP NetServer LP 2000r and LP 1000r systems require that the second
instance of the IDEATA.HAM driver be deleted. Highlight the second instance
of the IDEATA.HAM driver, press delete, and continue with the installation.
19. Ensure that you see the same instances of drivers as Network Adapters in your
system. If there are drivers missing use Options to add missing drivers. Otherwise,
highlight Continue and press Enter.
NOTE: To operate NetRAID adapters in I20 mode, refer to the section
Completing the Installation of the HP NetRAID-1Si/NetRAID-3Si I2O Driver on
NetWare 5.1 after the initial installation of NetWare.
20. If prompted that Existing NetWare partitions and volumes have been detected,
select to Remove all NetWare volumes and NetWare/NSS partitions.
21. When prompted to Create a NetWare partition and volume SYS, highlight Modify
if you wish to make changes, if not, highlight Continue and press Enter.
The installation program will proceed to copy NetWare files to your HP NetServer.
Wait till next prompt.
22. Enter the Server Name and click Next.
23. Highlight the first Free Space and click Create.
24. Enter a volume name, select a volume type and click OK.
25. Repeat steps 23 through 24 until all free space is made into volumes. Then click
Next.
26. Select to Mount all volumes when the server reboots by clicking Next.
27. Highlight the network board and specify the protocol. Once all Network boards have
been assigned a protocol, click Next.
NOTE: NetWare 5.1 requires at least one network card to have an IP address.
28. If you wish to configure the Domain Name Service, do so here. If not, click Next
and OK to the warning.