HP P5389A - Intel Pentium III-S 1.4 GHz Processor Upgrade Installation Manual page 8

NOTE: Refer to the Novell Netware 4.2 installation procedures for all other
installation issues. After completing the installation of Netware 4.2, you must
install the latest support pack from Novell. This can be downloaded from:
http://support.novell.com
Installing the SMP driver MPS14.PSM for Netware 4.2
The Netware 4.2 installation program no longer auto-detects more than one CPU and asks
the user if they wish to install SMP. SMP installation is now performed from the "install"
utility after the initial installation of Netware 4.2.
The installation program will attempt to add an older version of the SMP driver. The
correct SMP driver is located on the Netware 4.2 NOS driver diskette you created from
the NetServer Navigator CD in the a:\psm directory or will be loaded automatically with
the installation of Support Pack 7 or later.
Installing the NetRAID-1Si / NetRAID-3Si I2O driver on Netware 4.2
The HP NetRAID-1Si and NetRAID-3Si adapters can operate in either I2O or non-I2O
(traditional) mode. To configure the adapter to operate I2O mode use the NetRAID
Express Tools (version B.02.02 or later) that came with your NetRAID adapter or on the
NetServer Navigator CD. The I2O drivers are located on the Netware 4.2 NOS drivers
diskette in the \i2odac directory.
NOTE: I20 functionality is not supported on NetServer E series systems.
1. After the server installation process is complete, enter the commands:
DOWN
and press Enter. Followed by:
EXIT
and press Enter.
2. While in DOS copy the following files from the Netware 4.2 NOS drivers diskette
directory \i2odac to C:\NWSERVER:
IOPX.*
I2OPCI.*
BKSTROSM.*
SCSIOSM.*.
3. Then, while still in DOS, edit the STARTUP.NCF file and add the following lines: