HP P5389A - Intel Pentium III-S 1.4 GHz Processor Upgrade Installation Manual page 14

9. Change the prompt from Upgrade to New server and then arrow down to Continue
and press the [enter] key.
10. Inspect Server Settings. If you do not want the "SERVER" to automatically load after
reboot, MODIFY the Load Server at reboot parameter to NO.
11. Go to the "Server SET Parameters" and Choose Edit. A window will pop-up and
the following should be added:
SET MINIMUM PACKET RECEIVE BUFFERS=2500
SET MAXIMUM PACKET RECEIVE BUFFERS=12500
12. Inspect regional settings and modify if necessary.
13. Inspect Mouse and Video settings and modify if necessary
14. Wait a few minutes while system files are copied from CD
15. Inspect storage adapters and modify drivers if necessary. Choose Modify and delete
default NOS drivers and load appropriate storage drivers using the HP Drivers Disk if
applicable. Continue when complete.
Adding or Removing Drivers
Removing Drivers:
a) To remove a driver from the list, choose Deselect, highlight the device driver you
wish to remove, and then press [Enter] key. Repeat if necessary.
CAUTION: Do NOT deselect the IDEATA driver because it is used by the CD-
ROM Drive. For the LP 2000r and LP 1000r the second instance of
IDEATA.HAM driver should always be deleted.
b) Press either <ESC> or <Enter> at Continue Installation to go back to Drivers
Summary screen
Adding Drivers:
a) To add drivers Select additional drivers then press <Enter>
b) Press <Insert> key, then Press <F3> key, screen will show A:\ path
c) Insert new device drivers diskette into floppy drive, then press <Enter>
Identifying Slot Numbers for Controllers:
After adding a driver, you may be prompted for a Slot Number but may not know the
slot numbers for embedded onboard controllers. One trick to discover the correct slot
numbers is to press <ALT> <ESC> simultaneously to toggle to the system prompt.