HP P5389A - Intel Pentium III-S 1.4 GHz Processor Upgrade Installation Manual page 13

LOAD C:\NWSERVER\DRIVERS\BKSTROSM.HAM
LOAD C:\NWSERVER\DRIVERS\SCSIOSM.HAM
3. Restart the server and use the NWCONFIG utility to create the necessary partitions
and volumes.
4. Also load the NetRAID I2O compatibility driver, mril4_xx.ham, if:
- An HP NetRAID (D4943A) or HP NetRAID-1 (D4992A) is present in the system
(do not use the mega4_xx.ham driver in this case).
- You wish to use the Hewlett-Packard NetRAID Config for NetWare or the
Hewlett-Packard NetRAID Monitor for NetWare utility.
5. Use the NetRAID Express Tools (version B.02.02 or later) included with your
adapter or on the NetServer Navigator CD to set the HP NetRAID-1Si or HP
NetRAID-3Si into I2O mode.
NOTE: Booting from the HP NetRAID-1Si or HP NetRAID-3Si using the I2O
driver is not supported at this time. For more information consult the NetRAID
adapter documentation.
Netware 6.0 Installation
1. Install NetWare 6.0 according to the instructions below. You may skip the steps that
don't apply to the configuration you are installing.
NOTE: The NetWare installation program auto-detect feature will attempt to
match hardware with the appropriate drivers. Customers are advised to use those
drivers provided by HP when possible.
2. Boot your server to with the appropriate Netware 6.0 CD inserted in the CD-ROM.
The Netware 6.0 installation should begin automatically.
3. Choose Appropriate Language if prompted.
4. Choose Create a New Boot Partition.
5. If default setting is less than 1000 MB, modify Size of boot partition to create at least
1000 MB. Optimal partition size is 200 MB plus the amount of Server Memory,
minimum 1000 MB partition.
6. Choose Continue and then press any key to reboot at prompt. DO NOT REMOVE
THE NETWARE 6.0 CD. Installation will continue after the boot drive is initialized.
7. Choose Accept License Agreement.
8. Change the prompt from Express to Custom.