HP P5389A - Intel Pentium III-S 1.4 GHz Processor Upgrade Installation Manual page 9

Load bkstrosm.ham
Load scsiosm.ham
4. Next, from the C:\nwserver command prompt enter:
server
5. Use the NetWare install utility to create the necessary partitions and volumes.
Also load the NetRAID I2O compatibility driver, mril4_xx.ham, if:
- An HP NetRAID (D4943A) or HP NetRAID-1 (D4992A) is present in the system
(do not use the mega4_xx.ham driver in this case).
- You wish to use the Hewlett-Packard NetRAID Config for NetWare or the
Hewlett-Packard NetRAID Monitor for NetWare utility.
NOTE: Booting from the HP NetRAID-1si or HP NetRAID-3si using the I20
driver is not supported at this time. For more information, see your NetRAID
Adapter documentation.
NetWare 5.1 or NetWare Small Business Suite 5/5.1 Installation
Install NetWare 5.1 or NetWare Small Business Suite 5/5.1 according to the instructions
below. You may skip the steps that don't apply to the version of NetWare you are
installing.
NOTE: The NetWare installation program auto-detect feature attempts to match
hardware with the appropriate drivers. To run HP NetRAID-1Si or HP NetRAID-
3Si adapters in I2O mode, you will need to do it after the initial installation of
NetWare 5.1. See the section
1Si/HP NetRAID-3Si I2O driver on NetWare 5.1/Small Business Suite
NOTE: At least a 250 MB DOS partition must already exist on your hard drive
and your CD-ROM drive should be accessible. For detailed instructions, refer
back to the section
.
MSCDEX.EXE
1. Remove the HP NetServer Navigator CD-ROM and any floppy diskettes from the A:
drive and boot your server into DOS.
2. Create a directory named NWUPDATE.
3. Copy all drivers from the NOS Drivers disk to the NWUPDATE directory.
4. Remove the NOS Drivers disk from drive A: and reboot your HP NetServer using the
NetWare CD-ROM, the NetWare 5.1 installation will automatically begin.
Completing the Installation of the HP NetRAID-
Installing the CD-ROM Drive in DOS with FDATACD.SYS and
5/5.1.