HP P5389A - Intel Pentium III-S 1.4 GHz Processor Upgrade Installation Manual page 19

17. The NetWare 6.5 installation will begin the preliminary DOS file copy. When complete,
select and load the proper drivers for the following subsystems:
Storage Adapters – varies by server model
Network Adapters – varies by server model
18. Create the SYS: volume. The default is 4 GB, which is a satisfactory size for most
installation types.
19. Once the SYS: volume has been created, the NSS Management Utility screen is presented
where additional disk operations can be performed. This step is optional, and can be
skipped by selecting Continue Installation.
20. The NetWare 6.5 installation will begin the system file copy and will load the Installation
GUI when complete.
Note
Software RAID 5, although available as an option by selecting
RAID Devices, will not be supported by Novell or HP until at least
NetWare 6.5 Support Pack 1.
21. When the GUI loads, you have the option to choose a server type based upon the
anticipated use of the server. This option is called a Pattern Deployment, which customizes
certain settings during installation to optimize the server for the pattern selected. Unless you
are installing a server to meet one of the listed Patterns, HP recommends selecting Basic
NetWare File Server.
22. Review the summary screen to ensure that you meet the minimum hardware requirements
for the selected server pattern type, and then select Copy Files.
23. When prompted, insert the NetWare 6.5 Products CD. Allow the CD ample time to mount
(about 30 seconds), then select OK to continue the file copy process.
24. When prompted, insert the NetWare 6.5 License diskette. The first license file required is
for cryptography and will have an .NFK extension. It should be located in the \License
subdirectory on the diskette.
25. Select the Network Protocols for the installed network cards and enter the appropriate
information. IP and/or IPX can be selected from the Main screen. Advanced settings can
be entered by selecting the Advanced tab from the Main screen.
26. If desired, enter the server DNS host name and the Name Server IP Address. This
information is optional and can be skipped if DNS is not used on the network.