Internal Peripherals Installation Overview - HP 9000 Installation Manual

D class and r class internal peripherals enterprise servers

Hide thumbs Also See for 9000:

D Class Internal Peripherals

Installation

CAUTION

NOTE

Internal Peripherals Installation

Overview

If you are adding the Fast/Wide SCSI (Hot-Swap) option to a Model D2xx

server (step K in the list below), you must perform a full system backup

before starting the installation procedures.

Fast/Wide SCSI (Hot-Swap) disks are standard on Model D3xx servers,

and are available as an option on Model D2xx servers. The hot-swap disk

capability allows you to add Fast/Wide SCSI disks while power is on.

To install internal peripherals (other than Fast/Wide SCSI disks), you

must turn off system power, and open the server cabinet to gain access to

the cabinet interior. An overview of the procedures is given below:

A. Install Fast/Wide SCSI (hot-swap) disks.

B. Turn off power to the system.

C. Remove the front bezel.

D. Remove the side panel.

E. Remove the EMI cover.

F. Configure your peripheral, if necessary.

G. Select the peripheral slot in the cabinet.

H. Install the IDE floppy drive.

I. Install removable media drives (CD-ROM, DDS or quarter-inch tape

drives).

J. Install Single-Ended SCSI disks (Model D2xx only).

K. Install the Fast/Wide SCSI (hot-swap) disk option (Model D2xx only).

L. Replace the EMI cover.

M. Replace the side panel.

N. Replace the front bezel.

1- 1

Table of Contents