HP 300X - JetDirect Print Server Administrator's Manual page 82

Table 7.6 TCP/IP Configuration Messages (1 of 2)
Message
TCP STATUS:
HOST NAME:
CONFIG BY
IP ADDRESS:
SUBNET MASK:
DEF. GATEWAY:
SYSLOG SERVER:
IDLE TIMEOUT:
BOOTP SERVER
82 HP Jetdirect Configuration Page Messages
Description
Current TCP status.
DISABLED: Indicates that TCP/IP was manually disabled.
READY: Indicates the HP Jetdirect print server is awaiting
data.
INITIALIZING: Indicates that the print server is searching
for the BOOTP server, or trying to get the configuration file
through TFTP.
NOT IN USE: Code is in the middle of a download.
The host name configured on the print server. It may be
truncated. NOT SPECIFIED indicates that no host name
was specified in the BOOTP configuration information, or
TFTP configuration file (using a "name:" entry).
The location from which the print server is obtaining or has
obtained its IP configuration information. The options are
BOOTP, RARP, default IP, BOOTP/TFTP, DHCP,
DHCP/TFTP, or USER SPECIFIED (Telnet, printer's
control panel, HP Web Jetadmin, or other).
The Internet Protocol (IP) address assigned to the
HP Jetdirect print server. This is a required entry for
operation of the print server.
The IP subnet mask configured on the HP Jetdirect print
server. NOT SPECIFIED is indicated if no subnet mask has
been configured, or if the subnet mask is zero.
The IP address of the gateway used when sending packets
off the local network. Only one default gateway may be
configured.
Marks the IP address of the syslog server configured on
the print server. NOT SPECIFIED indicates no syslog
server has been configured, or the syslog server IP
address is zero.
The timeout value expressed in seconds after which the
print server closes an idle TCP print data connection.
Acceptable values are integers between 0 and 3600. A
value of zero turns off the timeout mechanism.
The IP address of the system that responds to the print
server's BOOTP request with configuration data. This
parameter is omitted when the print server is not
configured using BOOTP. NOT SPECIFIED indicates that
the server's IP address field in the BOOTP reply packet
was zero.
ENWW