HP 300X - JetDirect Print Server Administrator's Manual page 69

Table 7.2 General HP Jetdirect Messages (1 of 10)
Message
ARP DUPLICATE IP
ADDRESS
BABBLE ERROR
BAD BOOTP REPLY
BAD BOOTP TAG SIZE
BOOTP/DHCP IN
PROGRESS
CF ERR - ACCESS LIST
EXCEEDED
CF ERR - FILE
INCOMPLETE
CF ERR - INVALID
PARAM
CF ERR - LINE TOO
LONG
CF ERR - MISSING
PARAM
CF ERR - TRAP LIST
EXCEEDED
CF ERR - UNKNOWN
KEYWORD
ENWW
Description
The ARP layer has detected another node on the network
using the same IP address as the HP Jetdirect print
server. Extended error information below this message
shows the hardware address of the other node.
Run the power-on self-test: turn the printer off, then on
again. If the error persists, replace the HP Jetdirect print
server. For information on replacing your HP Jetdirect
print server, see the hardware installation guide for your
print server.
An error was detected in the BOOTP reply that the
HP Jetdirect print server received. The BOOTP reply
either had insufficient data in the UDP datagram to contain
the minimum BOOTP header of 236 bytes, had an
operation field that was not BOOTPREPLY(0X02), had a
header field that did not match the print servers hardware
address, or had a UDP source port that was not the
BOOTP server port (67/udp).
The tagsize in a vendor specific field in the BOOTP reply
is either 0, or greater than the remaining number of
unprocessed bytes in the vendor specified area.
The HP Jetdirect print server is currently in the process of
obtaining its basic IP configuration information through
BOOTP/DHCP, and has not detected any errors.
The TFTP configuration file specified too many access list
entries using the "allow:" keyword.
The TFTP configuration file contained an incomplete last
line that did not end in a newline character.
A line in the TFTP configuration file contained an invalid
value for one of the parameters on that line.
A line being processed in the TFTP configuration file was
longer than the HP Jetdirect print server could accept.
A line in the TFTP configuration file was missing a required
parameter.
The TFTP configuration file specified too many trap
destination list entries using the "trap-destination:"
keyword.
A TFTP configuration file line contained an unknown
keyword.
HP Jetdirect Configuration Page Messages 69