HP 300X - JetDirect Print Server Administrator's Manual page 76

Table 7.2 General HP Jetdirect Messages (8 of 10)
Message
PSERVER CLOSED
CONNECTION
READY
RECEIVE BUFFER
ERROR
RETRY ERROR
SQE ERROR
TFTP IN PROGRESS
TFTP LOCAL ERROR
TFTP REMOTE ERROR
TFTP RETRIES
EXCEEDED
TRANSMIT ERROR
TRYING TO CONNECT
TO SERVER
TURN PRINTER OFF/ON This message may appear after you upgrade to a new
76 HP Jetdirect Configuration Page Messages
Description
The print server requested a termination of the connection
with the HP Jetdirect print server. No error exists or is
indicated. Make sure the print server is running, and
restart it if necessary.
The HP Jetdirect print server has successfully connected
to the server and is awaiting data.
Run the power-on self-test: turn the print server off,
then on again. If the error persists, replace the
HP Jetdirect print server.
Check the Ethernet cable. Make sure your HP Jetdirect
print server is correctly attached to your network.
Run the power-on self-test: turn the print server off,
then on again. If the error persists, replace the
HP Jetdirect print server.
The HP Jetdirect print server is currently in the process of
obtaining its basic IP configuration information through
TFTP and has not detected any errors.
The TFTP transfer of the configuration file from the host
to the HP Jetdirect print server failed with the local print
server encountering some form of inactivity timeout, or
excessive retransmissions situation.
The TFTP transfer of the configuration file from the host
to the HP Jetdirect print server failed with the remote host
sending a TFTP ERROR packet to the print server.
The overall retrying of the TFTP transfer of the
configuration file from the host to the HP Jetdirect print
server has exceeded a retry limit.
Check the network topology and verify all cable segments.
The HP Jetdirect print server is trying to connect to the
print server or NetWare file server after being configured.
Wait for the print server to establish a connection with the
print or file server.
version of firmware. When this message appears, turn the
print server off, then back on to enable any new
functionality that was recently downloaded.
ENWW