HP 300X - JetDirect Print Server Administrator's Manual page 71

Table 7.2 General HP Jetdirect Messages (3 of 10)
Message
INITIALIZING TRYING
TO CONNECT TO
SERVER
INVALID GATEWAY
ADDRESS
INVALID IP ADDRESS
INVALID SERVER
ADDRESS
INVALID SUBNET MASK
INVALID SYSLOG
ADDRESS
INVALID TRAP DEST
ADDRESS
I/O CARD INITIALIZING
(INIT)
I/O CARD NOT READY
I/O CARD READY
LAN ERROR-AUTO
REMOVAL
LAN ERROR-BABBLE
ENWW
Description
The HP Jetdirect print server is trying to connect to the
NetWare server(s). This is a normal message. Wait until
the connection is established or another status message
appears.
The default gateway IP address specified for the
HP Jetdirect print server (through BOOTP or NOVRAM)
is an invalid IP address for specifying a single node.
The IP address specified for the HP Jetdirect print server
(through BOOTP or NOVRAM) is an invalid IP address for
specifying a single node.
The TFTP server IP address specified for the HP Jetdirect
print server (through BOOTP) is an invalid IP address for
specifying a single node.
The IP subnet mask specified for the HP Jetdirect print
server (through BOOTP or NOVRAM) is an invalid subnet
mask.
The syslog server IP address specified for the
HP Jetdirect print server (through BOOTP) is an invalid IP
address for specifying a single node.
One of the SNMP trap (Trap PDU) destination IP
addresses specified for the HP Jetdirect print server
(through TFTP) is an invalid IP address for specifying a
single node.
The HP Jetdirect print server is initializing the network
protocols. For more information, see the network
operating system status line on the configuration page.
There is a problem with the print server or its configuration.
Following the I/O CARD NOT READY message is a status
message. See this table for a detailed explanation of all
status messages.
The HP Jetdirect print server is connected and awaiting
data.
Run the power-on self-test: turn the printer off, then on
again. If this message reappears on another configuration
page, you may have a problem with one of the HP Jetdirect
print servers on your network. Check all the print servers
on the network for proper operation.
Check the network connections. If the connections are
intact, run the power-on self-test: turn the printer off, then
on again. If the error persists, replace the HP Jetdirect
print server. For replacement instructions, see the
hardware installation guide for your print server.
HP Jetdirect Configuration Page Messages 71