HP 300X - JetDirect Print Server Administrator's Manual page 37

Table 3.3 Telnet Configuration Parameter Examples (1 of 2)
IP Address
Parameter
Example
Subnet Mask
Example
Default Gateway
Example
Syslog Server
Example
Protocol
Enabling/Disabling
Example
Idle Timeout
Parameter
Example
Banner Page
Parameter
Example
ENWW
ip:
192.168.10.1
subnet-mask:
255.255.255.0
default-gw:
192.168.10.2
syslog-server:
192.168.10.3
IPX/SPX: 1
dlc-llc: 1
ethertalk: 1
idle-timeout:
120
banner: 1
where ip identifies the parameter
and 192.168.10.1 specifies the
address for the printer. By typing
this parameter, you can overwrite
the IP address used to make the
Telnet connection with one you
have selected.
where subnet-mask identifies the
parameter and 255.255.255.0
specifies the subnet mask.
where default-gw identifies the
parameter and 192.168.10.2
specifies the IP address of the
gateway.
Note: If the HP Jetdirect print
server is configured by DHCP and
you change the subnet mask or the
default gateway address (using
front-panel, Telnet, or other tool),
you should change the IP address
to release the present IP address
back to the DHCP server IP
address pool.
where syslog-server identifies
the parameter and
192.168.10.3 specifies the IP
address of that server.
(1 enables, 0 disables)
(1 enables, 0 disables)
(1 enables, 0 disables)
where idle-timeout identifies
the parameter and 120 specifies
the number of seconds an idle print
data connection is allowed to
remain open. If you set this
parameter to 0, the connection
does not terminate and no other
host is able to make a connection.
(1 enables, 0 disables)
TCP/IP Configuration 37