Using Dhcp - HP 300X - JetDirect Print Server Administrator's Manual

Table 3.2 TFTP Configuration File Parameters (3 of 3)
telnet:
port:
banner:

Using DHCP

Dynamic Host Configuration Protocol (DHCP, RFC 2131/2132) is
one of several auto configuration mechanisms that the HP Jetdirect
print server uses. If you have a DHCP server on your network, the
HP Jetdirect print server automatically obtains its IP address from
that server and registers its name with any RFC 1001 and
1002-compliant dynamic name services.
Note
Note
26 TCP/IP Configuration
If set to 0, this parameter instructs the print server not to
allow incoming Telnet connections. To regain access,
change the setting in the TFTP configuration file and
power cycle the print server, or cold reset the print server
to factory default values. If this parameter is set to 1,
incoming Telnet connections are allowed.
For multiport Jetdirect print servers, identifies the port (1,
2, or 3) for port-specific commands. The default is 1.
A port-specific parameter that specifies printing an LPD
banner page. 0 disables banner pages. 1 (default)
enables banner pages.
DHCP services must be available on the server.
Refer to your system documentation or online help
to install or enable DHCP services.
If the Jetdirect print server and BOOTP/DHCP
server are located on different subnets, IP
configuration may fail unless the routing device
supports "BOOTP Relay" (allows the transfer of
BOOTP requests between subnets).
ENWW