Sending Data To A Computer From The Extra Tab - HEIDENHAIN ND 1300 Operating Instructions Manual

16

Sending data to a computer from the Extra tab

Touch a data icon shown in the Extra tab to send the corresponding data element for the current position or
selected feature to a computer over the serial port. Touch the Extra tab to display the data choices.
Touch the Extra tab...
NOTE
The Extra tab is configured in the Display setup screen. Please refer to
Chapter 10: Setup for details.
The data sent to the serial port always corresponds to the information displayed in the DRO screen. The
information types are shown in the upper-left corner of the screen and are:
• Current position (no feature selected)
• Feature measurement (feature selected)
NOTE
Touching
icon for an inap-
propriate
type produces no
result. For example, touching
the diameter icon when a circle
feature is selected in the feature
list sends diameter data to the
serial port, however, touching
the angle icon when a circle is
selected produces no result.
QC-300 Series User's Guide
an
data
Send current position data...
to display the data choice icons
or send feature measurement data